Electrohome EAnos700 Instruction Manual download pdf (Page 8)

- 8 -

BATTERY INSTALLATION OF REMOTE CONTROL

• The remote control is equipped with one CR2025 (3V) lithium battery.

• To replace the battery, hold the remote level and press the clasp with

the thumb in the right direction of the arrow in the illustration, and take

out the battery compartment by sliding with forenger towards you.

Take out the battery compartment from the remote control. Install a

lithium battery (CR-2025) in the compartment with the positive polarity

turned up. Hold level and push the battery compartment into the

remote control lightly until it clicks into place.

RAISING AND LOWERING THE LID

IMPORTANT:

To open the lid, raise it as far as it will go until the lid support bracket "locks" in the open position. To close

the lid, lift it upward slightly and pull the bracket gently towards you until the bracket "unlocks", and then

gently lower the lid.

TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID CLOSED. ALWAYS RAISE THE LID TO

RELEASE THE LID SUPPORT BRACKET.

PROTECT YOUR FURNITURE

This model is equipped with non-skid rubber "feet" to prevent the product from moving when you operate

the controls. These ‘feet’ are made from non-migrating rubber material specially formulated to avoid

leaving any marks or stains on your furniture. However, certain types of oil based furniture polishes, wood

preservatives, or cleaning sprays may cause the rubber "feet" to soften, and leave marks or a rubber residue

on the furniture. To prevent any damage to your furniture we strongly recommend that you purchase small

self-adhesive felt pads, available at hardware stores and home improvement centers everywhere, and

apply these pads to the bottom of the rubber "feet" before you place the product on ne wooden furniture.

POWERING ON THE UNIT

1. To turn the system ON, press the POWER button on the front panel, and set the volume to a low level.

The POWER indicator lights up.

2. Press the FUNCTION selector buttons(AM/FM/CD/USB/AUX IN/PHONO) to select your desired function.

3. Start to adjust the volume by using the VOLUME control.

4. When you have nished using the system, press the POWER button again to turn o the unit. The

POWER indicator will turn o.

PREPARATION FOR USE

OPERATION

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

Electrohome EAnos700 Instruction Manual Page 8