Electrohome EAnos700 Instruction Manual download pdf (Page 7)

- 7 -

AC plug

AC outlet

PREPARATION FOR USE

Transit Screw

Tone Arm

Lock Lever

Stylus Cover

UNPACKING AND SETUP

• Carefully remove the unit from the display carton and remove

all packing material from the unit

• Unwind the AC power cord and extend it to its full length

• Unwind the FM Antenna wire and extend it to its full length

• Place the unit on a stable, level surface, close to an AC outlet,

out of direct sunlight, and away from sources of excess heat,

dust, moisture, humidity, or strong magnetic elds

• Raise the lid to expose the record player. The record player has been

secured for shipment with a transit screw. Use a coin or screwdriver

to TURN THE TRANSIT SCREW CLOCKWISE – THIS WILL ALLOW

THE TURNTABLE TO "FLOAT" AND TURN FREELY.

• Remove the opaque white plastic stylus cover from the turn-table

stylus by sliding it in the direction of the arrow.

• Discard the stylus cover.

• Remove the twist-tie that was used to secure the tone arm

during shipment.

• Release the tone arm lock lever.

• Connect the plug to your AC outlet, as shown below.

POWER SOURCE

This system is designed to operate on normal 120V 60Hz AC only. Attempting to operate this system from

any other power source may cause damage to the system, and such damage is not covered by your warranty.

This system is equipped with a polarized AC power plug having one blade wider than the other. This is a

safety feature. If this plug does not t into your existing AC outlet, do not try to defeat this safety feature

by altering the wide blade to make it t into your outlet. If this plug will not t into your outlet, you

probably have an outdated non-polarized AC outlet. Have the obsolete outlet changed by a qualied

licensed electrician.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

No comments

Electrohome EAnos700 Instruction Manual Page 7