Electrohome EAKAR300 Instruction Manual download pdf (Page 12)

- 12 -

OPERATION

Preparation

This unit is designed to play CD’s bearing the identication logo. If CD’s do not conform to the CD standard they may

not play properly.

• Fingerprints and dust should be carefully wiped o with a soft cloth. Wipe in a straight motion from the centre of

the disc to the outside edge.

• Never use chemicals, such as record cleaning spray, antistatic sprays or uids, benzene or thinner to clean compact

discs. These chemicals will permanently damage the plastic surface of the disc.

• Always place the compact disc on the disc tray with the label facing upward. Compact discs can be played on only

one side.

• To remove a disc from its storage case, press down on the centre of the case and lift the disc out, holding it carefully

by the edges.

• Discs should be returned to their cases after use to protect them from dust and scratches.

• To prevent warping the disc, do not expose it to direct sunlight, high humidity or high temperatures for extended

periods of time.

• Do not apply paper or write anything on either side of the disc. The inks used in some felt-tip pens may damage

the surfaces of the disc.

Turning ON/OFF

To turn the karaoke system on or o:

1. Press POWER ON/OFF button, to turn on the karaoke system. The ON/OFF LED will light up.

2. Press POWER ON/OFF button again to turn o the system. The ON/OFF LED will turn o.

Loading a disc

To place a karaoke disc in the karaoke player:

1. Press the OPEN button to open CD+G compartment door. Place a disc in the compartment with the printed

side upwards.

2. Gently close the CD door to the CD+G compartment. The karaoke system will begin to read the disc.

3. Press PLAY/ PAUSE to play the disc. If no disc is loaded, it will display “- -”. (Refer to the TROUBLESHOOTING guide

on page 11 if a disc has loaded but the total tracks do not appear).

Play/Pause Mode

To play/pause a disc:

1. Press the PLAY/PAUSE button to start playing disc. The rst track will display on the LED display.

2. To pause playback, press the PLAY/PAUSE button, and to resume playback, press the PLAY/PAUSE button again.

Note: Pressing pause when a CD+G is playing may cause distorted lyrics on the monitor. Any distortion will remain until

the whole screen is refreshed during an instrumental break or you stop the song and start it from the beginning.

Stop mode

To stop playback:

• Press the STOP button to stop playback. (The total number of tracks on the disc will be displayed on the screen)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

No comments

Electrohome EAKAR300 Instruction Manual Page 12